Professional Water Heater Installation in San Diego—Almco Plumbing Case Study
Proper water heater installation is key to ensuring the safe and efficient operation of the unit over time. Replacing outdated equipment with modern models can significantly reduce energy costs, which is especially important for owners of multi-unit buildings and apartment complexes. This case study outlines the gas boiler replacement for residential apartments in San Diego, with an emphasis on the technical aspects of the project.
Technologies & Services
Customer’s Problem—Brief Description
At the customer’s request, Almco Plumbing specialists replaced a boiler in an apartment complex in San Diego. The old unit had been in use for over 15 years and had become outdated, showing signs of wear—specifically, internal cracks had caused it to start leaking. Although commercial water heaters typically have a lifespan of around 10 years, this one had operated for 15.
Since the damage was beyond repair, the homeowner needed to replace the leaking water heater with a new, more efficient, and environmentally friendly model. As of 2024, new heaters in California must comply with current environmental standards and have low CO2 emissions. By upgrading to an eco-friendlier model, homeowners may be eligible for a rebate through SDG&E’s “Call Rebate Program”.
The following section describes the full installation and safe connection process in accordance with safety standards for such equipment.
Dismantling the Old Boiler
Prior to beginning the dismantling process, it was necessary to shut off the gas and water supplies—a critical safety measure. All water was drained from the plumbing system and the water heater tank before supply lines were disconnected.
Some pipes were cut using a bandsaw, while others were unscrewed at the connection points. Copper piping was selected for its long service life and corrosion resistance. Because the commercial tank remains heavy even when empty, a team of five specialists was required to safely extract it. The dismantled unit was then transported for material recovery and recycling.
Installing the New Water Heater
Selecting a modern high-efficiency boiler significantly reduces energy consumption and cuts CO2 emissions by optimizing gas consumption and heat exchange efficiency.
- Preparation: The Almco team prepped the installation area by removing old gas hoses, leveling the concrete base, and cleaning pipe ends of oxidation for a clean, secure connection to the plumbing system.
- Pipe Soldering: All pipe ends were inspected for damage, replacing any deformed sections with new copper piping. Soldered joints were created using tin solder and a handheld gas torch to prepare for installing shut-off ball valves on supply and return lines.
- Boiler Placement & Pressing: The new commercial-grade water boiler was anchored to the concrete floor. Shut-off ball valves were joined to the copper lines using crimp fittings and ProPress tools, creating a durable, flame-free seal.
- Recirculation & Drainage: A drain pipe with a dedicated shut-off valve was connected to the tank for future maintenance. A copper recirculation line and air release hose were installed to prevent airlocks and balance hot water delivery throughout the building.
- Gas Line Connection: The gas line was tied into the threaded fitting (detailed in our Efficient Gas Line Installation case). Threaded connections were sealed with thread sealant for long-term reliability.
- Exhaust Venting: A new galvanized steel vent pipe was added to ensure proper exhaust ventilation, preventing combustion gases from entering living spaces in strict accordance with fire safety codes.
- Final Testing: System testing was performed by an Almco Plumbing engineer to verify overall operational safety and temperature control.
























